 |
INSTALLATION FOR COMPETITOR CLUTCH |
 |
 |
 |
|
|||
| A. CC-100-CS Set of 7 steels B. CC-100-CP Set of 5 friction plates C. CC-100-PP Pressure plate D. CC-100HUB Hub E. CC-100HH Hub housing F. EHB-100 Hub bearing G. CC-100HR Housing retainer with 4-5/16-18 x 3/4 buttonhead screws H. CC-100HN Hub nut with adjustment screw and nut I. CDCS-100 Set of 9 clutch springs J. CDSB-100 Set of 9 shoulder bolts K. CC-158 C-Clip L. CC-244 C-Clip |
||||
| Remove 4 bolts on back plate, remove the 9 shoulder bolts and springs from pressure plate. Remove clutch plates and steels and install hub assembly into clutch basket. Re-install housing retainer using the 4 buttonhead screws. Install basket assembly onto transmission mainshaft. Install hub nut with seal and tighten to Harley specs. Re-install clutch plates and steels, install 2 steels first then alternate fibers and steels ending with a steel. Install pressure plate with springs and shoulder bolts, screw shoulder bolts all the way in and tighten slightly be sure to use thread locker. We supply 9 springs and bolts, a stock application may only need 4 to 6 bolts and springs, use the amount of springs and bolts for your application. Install adjustment screw and adjust clutch per Harley specs and install jam nut. |
||||
| Hub installed in basket | Back side of basket | Housing retainer being installed | ||
 |
 |
 |
||
