pop up description layer
Home

WHAT'S NEW?

Back to previous page
 

_blank

BDL NEW BELT DRIVE FOR 2007-2008 SOFTAILS

BDL'S new belt drive for all 2007-2008 softails is the perfect addition for any Harley enthusiest. It has a slick new design with features such as BDL's new ball bearing clutch and the drive is only 2 3/4" wide.

(please click here for more information)

 
 

_blank

BDL NEWLY DESIGNED GMA FORWARD CONTROLS

These newly designed forward controls are the perfect addition to the new GMA Brakes Product line.

(please click here for more information)

 

New Adjustment Screws

A - CDAS-300 2-1/4" overall length & zinc plated. Used with all BDL Ball Bearing pressure plates as in BPP-100 and SS-2 2" belt drive.

B - CDAS-100 2-9/16" overall length and dark zinc plated . Used with all BDL belt drives, both open style and closed primary style without Vall Bearing clutch.

C - CDAS-500 2-1/2" overall length with flat surface on un-threaded shaft & black oxide coating. Used with all BDL chain drive applications, both coil spring and Ball Bearing style pressure plates.

New Hand Controls from BDL

Our NEW design includes a threaded ball end plunger that offers positive engagement into the newly designed piston. The new lever design gives a more positive and comfortable feel when stopping or shifting.

BDL'S NEW Twin Cam - Cam Cover

BDL's New Cam cover is made from 6061T6 Billet aluminum. Designed, precision machined and polished in house, with all of the quality standards you come to expect from BDL. The kit includes the special bolt, cam cover end adaptor and seal, pictured left and below.

This kit converts all Twin Cam 88 engines to earlier electronic ignitions, and can be used with any aftermarket ignition and rotor cup system. It’s great for building customs with Twin Cam 88 engines to simplify the wiring process. You can now wire your bike with all aftermarket Evolution wire harnesses. This kit is for engines with gear driven cams only.
 

IMPORTANT UPDATE AND PRODUCT CHANGE

BDL items EVO-900 Series 3" Belt Drive with Outboard Support, EVO-3000 Outboard Support Retro Fit Kit and TF-2000 have been changed.

We have eliminated the front pulley and engine shaft support and front bearing of the outboard support.

The reason for this change was due to the many aftermarket components that come together on a special construction motorcycle, we find that a lot of these components do not allow proper alignment of the entire motorcycle.

When using an outboard support that was intended to keep the front engine and rear transmission shafts from moving excessively, improper alignment will cause unusual wear and premature failure of the sealed bearings.

By supporting only the rear shaft, which is all that is really needed, we have eliminated any potential problems that mis-alignment may cause.
 

Installation for Ball Bearing Chain Drive

Now online in the Installation Guides section.

 
 
 
 

Put some BALLS in your clutch!

BDL's new "Patent Pending" Ball Bearing Lock Up Clutch is now standard equipment with all of our new 2" drives, and is available as a retro fit with all BDL belt drives with coil spring clutch except our Top Fuel Drives.

Also available for Primo Pro-Clutch belt drive models 1990-2007 and stock Harley 1998-2007.

 
Changed 3" softail motor plate design

BDL's new design eliminates the need for an alternator cover. The unique personalized starter housing design sets off the entire kit.
 

2" SS-2 Belt Drive

BDL's 2" BELT DRIVE features our ball bearing lock up clutch and several designs of our full covers. Fits Softail 1990 to 2006 models.